At a Glance
- Category
- 🏗️ Construction & Engineering
- Level
- Mid-Level
- Type
- Full-time
Before You Apply
- See if your CV gets past the software before NOV sees it
- Get every weak line rewritten
- Download a CV written for the Gulf
Free check in 60 seconds. Fixes $5.88 one-time, only if you want them.
- Produce parts as per the drawings provided and programs.
- Inspect and verify that each part is machined as per the specifications provided.
- Follow all the guidelines and instructions provided by the direct manager (supervisor or team leader).
- Maintain a neat and clean working environment. Follow all NOV safety rules.
- Programs mills/lathes, entering instructions (including zero and reference points, setting tool registers/offsets and proving part programs.
- Setup mills and lathes by installing and adjusting three/four-jaw chucks, tools and fixtures.
- Verifying all required gauges are readily available as per the drawing requirement with valid calibration records.
- Raise maintenance requests as required.
- Maintain continuity among work shifts by documenting and communicating actions, irregularities as needed.
- Complete production and quality records for each individual job.
- Raise non-conformity reports and inform the direct manager as per procedures.
- Communicate new developments and process improvement plans with the related team and direct manager.
- Follow other instructions assigned by the direct manager.
- Observe and ensure compliance with all Health/Safety/Environmental (HSE) regulations. Encourage safe working practices. Correct obvious hazards immediately and report them to the proper personnel.
- Sustain 5S and lean process as per company/departmental requirements.
Requirements
- •Ability to produce parts as per drawings and programs
- •Ability to inspect and verify parts against specifications
- •Knowledge of mills and lathes programming
- •Ability to setup mills and lathes with chucks, tools, and fixtures
- •Knowledge of gauge verification and calibration records
- •Ability to document and communicate actions between shifts
- •Knowledge of non-conformity reporting procedures
- •Compliance with HSE regulations
Responsibilities
- •Produce parts as per provided drawings and programs
- •Inspect and verify machined parts against specifications
- •Follow guidelines and instructions from direct manager
- •Maintain a neat and clean working environment
- •Program mills/lathes and enter instructions (zero/reference points, tool registers/offsets)
- •Setup mills and lathes by installing and adjusting chucks, tools, and fixtures
- •Verify availability of required gauges with valid calibration
- •Raise maintenance requests as required
Related Jobs4 similar jobs
Browse Similar
Before You Apply
- See if your CV gets past the software before NOV sees it
- Get every weak line rewritten
- Download a CV written for the Gulf
Free check in 60 seconds. Fixes $5.88 one-time, only if you want them.
GCC Info
Company
NOV
5000+ employees
NOV provides equipment and services to the oil and gas, and renewable energy industries. They offer solutions for drilling, completion, and production operations.