JR OFFSHORE HOOK-UP ENGINEER

Setup phase

• Review Project SOW, documents, and drawings deliverables

• Review Engineering documents / drawings and analysis from constructability point of view.

• Assist the OCM in preparing the list of project deliverables for the offshore scope

• Review lesson learned and best practise from previous projects

• Review IFB / AFC drawings for verification of scope of work

• Prepare and discuss with OCM to issue Purchase Requisition for hookup project material, that are not produced by engineering, and follow-up with procurement on finalizing and placing orders

• Conducting pre-engineering and pre-construction surveys as well as preparation of survey checklist and reports

All phases

• Coordinate with all departments for offshore project scope

• Support OCM in providing input for reports and client meetings

• Liaise with Vendors and third-party agencies on offshore execution issues

• Preparation of discipline hookup procedures and ensuring alignment with the latest AFC hookup drawings

• Preparation of tasksheets, workpacks, hydrotest packs (Piping discipline) and generation of Hookup MTO

• Tracking of materials, tools and equipment (incoming and issuance) through material control system. Raising requisitions as required for any shortages identified by Material Controller

• Bagging and tagging materials in line with prepared task sheets

• Ensuring validity of test equipment calibration certificates

Pre-offshore phase

• Prepare Risk Assessment Register, and attend corresponding meetings. Compile comments during meetings & forward to Client and all concerned parties within the company

• Prepare job cards for offshore hook-up works

• Ensure that pre-installation / load-out of required items for offshore execution (like rigging platforms, lifting slings etc.) are carried-out on time

• Ensure that latest and approved revision of all necessary documentation required for offshore execution is available on-board offshore spread

• Identification of carryover, with the respective Yard / Fabrication Engineer, and preparation of corresponding tasksheets and MTO

• Ensuring prefab items are identified, fabricated, and included in Load-out list

• Preparation of the Load-out List for Customs clearance formalities prior to offshore mobilisation